K.A.R. 92-56-4
Installation, inspection, and calibration standards.
# (a)
Each ignition interlock device installed at the direction of the division shall be done at the driver’s own expense, except as allowed by K.A.R. 92-56-2.
# (b)
A manufacturer shall ensure that each service provider meets the following requirements:
# (1)
Install each device in accordance with the manufacturer’s instructions. Each service provider shall, within two weeks of installation, inform the division each time a device has been installed;
# (2)
install each device so that the device will be deactivated if the driver has a BrAC of .03 or higher until a successful retest occurs;
# (3)
set each device so that if the driver fails the initial ignition interlock device test, a retest cannot be done for 15 minutes;
# (4)
set each device so that a rolling retest will be required of the driver of the vehicle within 10 minutes of starting the vehicle. Subsequent rolling retests shall occur as described in K.A.R.
Source: official source document (2022 KAR Book 4, Kansas Secretary of State)
In this article (9 sections)
- 92-56-1 · Ignition interlock device; definitions.
- 92-56-2 · Ignition interlock device; certification and standards.
- 92-56-3 · Insurance; policy limits.
- 92-56-4 · Installation, inspection, and calibration standards.
- 92-56-5 · Revocation of certification; penalties.
- 92-56-6 · Service provider; relocation and replacement.
- 92-56-7 · Security; tampering prohibitions; conflict of interest.
- 92-56-8 · Device removal.
- 92-56-9 · Proof of installation.